December 4, 2017 08:26 AM
We have two conventions coming up in 2018 that we will be showing our equipment at.
First off, we will be at PLASTEC West in Anaheim, California, February 6-8, 2018. Our equipment will be on display in the Hirate America Booth # 3911.
Click here to register for this event.
Second, May 7-11, 2018 in Orlando, Florida, we will be showcasing our equipment at NPE2018. Come see us in our booth - W4231.
Click here to register as our guest for this event.
See you at the shows!
December 4, 2017 --
August 9, 2017 06:34 AM
Size Reduction Specialists was recently profiled in a Special Report found inside the August 2017 issue of Plastics Machinery Magazine. The special report focuses on dedusting technology and makes a great mention of our DFS line of products. Check it out for yourself:
Plastics Machinery Magazine, August 2017 Special Report
August 9, 2017 --
February 3, 2017 07:09 PM
We congratulate our customer, Prism Plastics, for being profiled in the Onsite section in the January issue of Plastics Technology on pages 31 thru 37.
And we greatly appreciate their mention of SRS as an equipment supplier in the article:
"Scrap is granulated beside the press and regrind is recycled, when appropriate, in a closed loop. Prism uses SRS low-speed granulators because they produce granules that are consistently as close as possible to the original pellet size, with no longs or shorts,Continue reading
February 3, 2017 --
December 19, 2016 02:43 PM
In the spirit of the season, we extend a heartfelt Thank You to all of our customers. Best Wishes for this Holiday Season and a New Year of Health, Happiness and Prosperity. From All of us at Size Reduction Specialists.
December 19, 2016 --
June 2, 2016 09:35 PM
AVOID POOR QUALITY REGRIND AND PREMATURE CUTTER WEAR BY EVACUATING YOUR GRANULATOR PROPERLY!
It has been brought to our attention that a lot of processors are not evacuating the Bi-Cutter Screenless Granulator collector bins in a timely manner. This is critical because you are creating unusable material by pulverizing it and not cutting it properly. This affects the molding process and end-part quality.
For further information, please contact us.
June 2, 2016 --
«older posts newer posts»